Page 59 - Catalogo de Boquillas - Industrysystem

XA Components & Options

lowest flow rates available in the XA Hardware Assemblies for Non-
series (as low as 0.38 l/hr). They are Automatic Operation
generally not suitable for use with A. Plug. The minimum option D. Cleanout/Shutoff. Combines
liquids having a viscosity above 200 hardware assembly required for XA functions of hardware assemblies B
centipoise. operation. Provides neither cleanout and C in one unit.
By supplying the liquid under nor shutoff.
pressure, SR Setups may be used B. Shutoff. Turning the knurled
with liquids having a viscosity above knob will stop the flow of liquid to
200 centipoise. In this case, the liquid the nozzle. Should not be used to
flow rate is regulated by the fluid meter the flow of liquid.
cap, and can be determined by using C. Cleanout. Pressing the spring
the EF chart for the specific fluid cap. loaded plunger will force a small
diameter rod through the liquid
BASIC OPERATION
orifice, cleaning any obstruction. AIR ATOMIZING
The basic XA nozzle assembly Useful for intermittent spraying of a
consists of a body, a spray setup, liquid that may dry in the orifice
and a hardware assembly that can when not in use. PR Air Cap
provide shutoff and cleanout
capabilities.
Non-Automatic Operation
The XA00 Square Body is the basic
component of a nonautomatic XA
nozzle. Air and liquid feeds are
Fluid Cap
located at opposite ends, perpendi
SR Air Cap
cular to the spray.
The XA03 Body has air and liquid
feeds on one side, perpendicular to
FF Air Cap
the spray axis.
The XA05 Body has air and liquid
inlets located inline with the spray.
Hardware assemblies cannot be used XW Air Cap
ER Air Cap EF Air Cap
with the XA05 body.

PF Air Cap
XA00 Body
with C Hardware Call for the name of your nearest BETE representative. CALL 413-772-0846

XA03 Body

XA 01/02 Body
with E or F
Hardware
XA05 Body
www.BETE.com 77